Description / Type
Magma for use with catalyst converter, 230 V
This furnace unifies all the main elements necessary for
pre-heating, all in one machine. Apart from the top
technology such as the Pt-RhPt temperature sensor, the
four sided heating chamber and the hidden heating
elements etc., the main emphasis was placed upon the ergonomics, so that operation, programming and
ventilation is the best possible. Spacious:
Space for 4× size 6 plus 3× size 3 casting rings
Max. heat-up rate 900°C (1652°F) in 60 min.
Type S: PtRh-Pt temperature sensor
Even heat distribution:
Displayed temperature shows temperature in
casting ring height
Renfert catalyst converter for Magma
|230 v, 50 Hz
|160 x 180 x 120 mm
(6.30 x 7.09 x 4.72 inch)
|Max. heat-up rate in min.
|Type S temperature sensor
|430 x 500 x 450 mm
(16.93 x 19.69 x 17.72 inch)
|Free programmable stages
|Additional speed programme
|Firing chamber volume
|Weight catalyst converter
Catalytic converter for Magma
Description / Type
Catalyst converter 230V
The optional catalytic converter is centrally controlled
from the oven and is intelligently integrated into the programs.
In the standard program the catalytic converter is automatically shut off when it reaches 650°C (1202°F), which extends its life. It can be manually switched on again until the program stops.
If the program has finished and the technician does not switch off the Magma after the acoustic signal, the controller expects the insertion of speed investment compound and restarts the catalytic converter. Because the new casting rings are not at the same temperature as the interior of the oven, the gases given off by the wax would not be completely burnt off and would contaminate the room atmosphere and also settle on the honeycomb structure of the catalytic converter. Therefore the catalytic converter operates continuously in the speed program. This interconnection increases the service life of the catalytic converter and improves the quality of the air in your laboratory